Get Listed
A pressure value is useful only when its units and reference are understood. North Ridge Pumps' guide explains the differences between bar, psi, pascals and fluid head, and why comparing pump specifications without converting them correctly can lead to an unsuitable selection.
A value of six bar is very different from six psi. The numbers may look similar on a quotation or performance sheet, but the two units differ by a factor of approximately 14.5. This is a practical specification issue rather than a minor rounding difference.
Pressure is force divided by area
The basic relationship is P = F/A. In SI units, one pascal is one newton per square metre. Industrial pressures are often more conveniently stated in kilopascals, megapascals or bar because a single pascal is a small quantity.
One kilopascal equals 1,000Pa, one megapascal equals 1,000,000Pa and one bar equals 100,000Pa, or 100kPa. These relationships allow values expressed in different metric units to be compared on the same scale.
The units encountered on equipment
Bar is widely used in European pump and process specifications, while pounds per square inch is common on equipment originating in the United States. Atmospheres may also appear, using a defined pressure close to average sea-level atmospheric pressure as the reference unit.
Millimetres of mercury and Torr are encountered particularly in vacuum discussions. Inches of mercury appear in some US weather, HVAC and suction-side specifications. Metres of water column are another way of expressing a pressure difference as an equivalent fluid-column height.
The physical quantity may be the same, but the scales differ. A supplier's preferred convention does not change the duty the pump must meet, so the unit should remain attached to the value whenever information is exchanged.
Pressure and viscosity describe different properties
Pressure measures force per area. Dynamic viscosity describes resistance to flow or shear and is measured in pascal-seconds, with centipoise also widely used.
A gas may be at high pressure while having low viscosity. A thick liquid can resist movement even while resting at ordinary atmospheric pressure. Knowing one property therefore does not establish the other, although both can be important when selecting a pump.
Viscosity influences flow behaviour and losses; the pressure requirement concerns the force needed to meet the system duty. Treating the two as interchangeable can obscure why a pump performs differently with another liquid.
Head is related to pressure through density
Head is expressed as a height, normally metres or feet. The relationship is P = ρ × g × h, where ρ is fluid density, g is gravitational acceleration and h is head.
Because density is part of the equation, the same pressure corresponds to different liquid-column heights. Mercury is approximately 13.6 times denser than water, so a much shorter mercury column produces the same pressure as a water column.
Pump head and a pressure reading should therefore be compared using the properties of the actual fluid. A head stated for a pump should not automatically be treated as the same numerical pressure for every liquid.
Regional conventions can vary
North Ridge describes bar and kPa as common in the UK and Europe, with psi still present in parts of UK engineering. US equipment frequently uses psi, while kPa, MPa and bar are all encountered across Asian suppliers, depending on country and industry.
The guide's practical message is to check the units before comparing duty points, curves or quotations. Establishing a consistent basis for pressure, fluid density and head helps avoid selecting equipment for a substantially different duty. North Ridge can discuss those requirements with customers specifying a transfer or circulation system.
Source: North Ridge Pumps
For more information on Units of Pressure: Why Bar, PSI and Pascal Don't Always Mean What You Think talk to North Ridge Pumps Ltd