SLOSH FUEL TANK SEALER

Rustbuster Slosh Fuel Tank Sealer DUE TO THE CURRENT SITUATION SURROUNDING SUPPLIES OF PPE ALL SLOSH TANK SEAL KITS WON'T BE SUPPLIED WITH GLOVES. WE APOLOGISE FOR THIS TEMPORARY INCONVIENCE.? ? Slosh is designed for the sealing of steel, aluminium and GRP (glass fibre) petrol and diesel tanks. Tests with dilutions of up to 85% corn ethanol show no degradation or softening of the sealer, so it is more than capable of protection against the ethanol content of modern fuel in both current E10 and proposed E15 standards. We recommend a thorough cleaning of the tank interior with Rustbuster Tank-Kleen prior to application of the sealer. Kits are available that combine Slosh and Tank-Kleen. All previously applied sealers should be removed before application of Slosh, should you need to remove an exisiting/failing sealer please use Rustbuster AS-10 A 425ml can of Slosh will seal up to a ten gallon (50 ltrs) tank and is recommended for motorcycle tanks and small cars. A 850ml can will treat a tank size up to 20 gallons (100 ltrs). ? Tips for best results with Slosh To read instructions for using Slosh?click here>. Here are some tips for best results: Do... use some nuts, washers or sharp stones as an abrasive with the Tank-Kleen solution to help remove rust and old petrol deposits. Do... allow enough time for the tank to be 100% bone dry before you put the sealer into the tank. Do... remove or protect anything that you do not want Slosh to seal, including plugs, fuel gauge sender units, breather pipes and filters etc. ? Do Not... apply the sealer into a wet or even damp tank. It reacts with moisture and will cause a bubbling reaction. Do Not... allow the sealer to pool in a very thick layer as this will cause the solvents to get trapped within the coating, and this can also cause a bubbling reaction. ? Product description Clear or grey coloured moisture curing polyurethane for the sealing of fuel and oil tanks. Pack description 425ml or 850ml in clear or grey. Also available as a small or large kit with Rustbuster Tank-Kleen. Application Summary instructions as follows: Pour all of the Slosh into the tank and move the tank from side to side and upside down to fully coat the interior of the tank. When you have coated the tank put it down for ten minutes, and then repeat the process. Drain the remaining sealer back out of the tank via the drain plug into the tin.? We strongly recommend the above?ten minute?procedure and no other. For full Slosh instructions click here> Please note: a second coat of Slosh is not necessary, but if one is applied it must be done within ten hours. After ten hours it will not accept another coat and adding one will damage the integrity of the original coat. Shelf life We recommend storing upside down in a dry place at around 20c. In these conditions the product has a shelf life of 12 months. Do not store below 20c as this can affect performance. Disposal Allow the sealer to cure hard and dispose of as dry waste. Safety This is a solvent borne paint and care should be taken to avoid spray mist or vapour as well as contact between the wet paint and exposed skin and eyes. Avoid at all times inhalation by using a vapour cartridge respirator. Use suitable protective clothing, gloves and goggles.

For more information on SLOSH FUEL TANK SEALER talk to Rustbuster Ltd