Straight two-flute cutters for cutting birch ply

A range of cutters with solid Tungsten Carbide inserts brazed into steel shanks. especially suited to CNC cutting of plywood, although they are equally good at cutting MDF.

Cleaner top and bottom edge finish

Improved cross grain finish with reduced tear-out

Better chip clearance than either compression or down-cut spirals

Reduced up-lift on vacuum beds compared to up-cut spirals

Much reduced noise levels compared to spiral cutters

A cost effective alternative to STC spirals

An 8mm cutter with either a 5 degree down-shear or up-shear is available to aid clean cutting. The down-shear will improve the finish on the top face of veneered board

For more information on Straight two-flute cutters for cutting birch ply talk to Wealden Tool Co Ltd