search

Comparision of Battenfeld All Electric (Servo-Motor) CDK SE 1000/200 and the Hydraulically Powered Battenfeld CDC 1000/200 Injection Moulding Machines

Comparision of Battenfeld All Electric (Servo-Motor) CDK SE 1000/200 and the Hydraulically Powered Battenfeld CDC 1000/200 Injection Moulding Machines

This involved the manufacture of a natural polyacetal control switch produced from a six-impression cold runner mould. The same 35 mm diameter screw and barrel assembly with a shot capacity of 42% was used for both machines. Measurement was to 0.0001g of the individual and collective component weights. The process was allowed to stabilise prior to the each evaluation run and the three separate 500 shot runs on both machines were taken over a period of days.

Call us on +44 (0)1733 232211 for a copy of the full report

List your business

Would you like to register your company on one of the UK's largest and most effective Trade websites?

Are you looking for a reliable and consistent source of enquiries from your industry sector? Would you like to see why Find the Needle clients come back year after year to use our service? If so then feel free to register using the link 'here'.

Register
Office Address: