search

Hot Dipped Galvanised Goods Lift London

Hot Dipped Galvanised Goods Lift London
27/02/2017

Hot Dipped Galvanised Goods Lift London with 500kg capacity installed Camberwell London. Double Scissor Lift pit installed (pit by others) with a platform size 1850mm length x 1350mm wide closed height 400mm and total raised height 2400mm. Lift stoke 2200mm available limited to the required height of 1625mm using an adjustable upper limit switch. Lift speed approx 46 seconds to full height and power being 3ph 380-500v remote unit with 6M of hydraulic hose and cabling. Power pack housed within a protective cover. Lift supplied with the following; 2 x standard dead-man type wall mountable controls complete with scissor up, scissor down and e/stop buttons. Microprocessor based control system, housed within a lockable wall mounted enclosure located adjacent to the power pack. Box section supports fitted in each corner of the lift table base frame to prevent platform deflection whilst loading across all platform sides in the closed position. 4 x lifting eyes to assist in the lowering of the lift into the pit. 1100mm high mild steel handrails complete with mid rail and 150mm high kick plates suitable for mounting along both long sides of the lift platform. One short end will be fitted with an 1100mm high mild steel single outward opening hinged platform mounted gate complete with mechanical latch and electrical interlock. The remaining short end will be open as this will abut up against the upper level. The upper level will be fitted with a similar floor mounted infilled gate with a mechanical latch and electrical interlock so that the gate can only be opened when the lift is at the correct position. Mild steel galvanised woven mesh panels will be fitted behind the safety trip bars on both long sides and the front short end to enclose the scissor mechanism when in the raised position. The platform will be fitted with a tread plate finish for improved grip in wet/dusty conditions. The complete lift will be finished in a self-coloured hot dip galvanised finish due to the external location. Component parts finished in grey / black gloss.

Installed Camberwell New Road, Camberwell London SE5 0RW

For a quotation please contact; Manual Handling Solutions 58, Paige Close, Watlington, King's Lynn, Norfolk PE33 0TQ Tel 01553 811977 sales@manualhandlingsolutions.co.uk http://www.manualhandlingsolutions.co.uk http://www.goodslifts.website/double-scissor-table-goods-lift/

Enquiry Form



More News

Mezzanine Floor Goods Lift Park Royal London

Mezzanine Floor Goods Lift Park Royal London

Mezzanine Floor Goods Lift 1500kg Twin Mast 3 Stop installed Park Royal London. Platform size 3000mm x 3000mm finished anti-skid checker plate, finish...

Read More
Mezzanine Goods Lifts Dartford

Mezzanine Goods Lifts Dartford

Mezzanine Goods Lift installed Clipper Blvd East, Crossways Business Park, Dartford Kent 1000kg SWL with a clear platform size 1500mm x 1500mm, finish...

Read More
External Mezzanine Floor Goods Lift London

External Mezzanine Floor Goods Lift London

External Mezzanine Floor Goods Lift London with maximum working load 250kg, enclosed in a self-supporting mesh shaft. The platform will be 1200mm x 11...

Read More

Read More

Read More

List your business

Would you like to register your company on one of the UK's largest and most effective Trade websites?

Are you looking for a reliable and consistent source of enquiries from your industry sector? Would you like to see why Find the Needle clients come back year after year to use our service? If so then feel free to register using the link 'here'.

Register
Office Address: