Blog: Getting the most out of your Rendering and Plastering Machine

Daily Checks Spending 5 to 10 minutes carrying out checks on your Rendering and Plastering machine spray equipment before you begin your spray, is a great way to maintain the performance of your render or plaster spray machine. This short check in the morning can also help spot any faults there may be with your equipment. We recommend checking the below? Electric Rendering or Plastering Machines Water feed ? Are you getting a consistent supply of water with good pressure? Make sure you are the only person using that particular water supply and no one is going to turn you supply off. Using a water butt is a good way of getting a consistent feed. Water filter ? Make sure it is clear and allowing water to pass through. On 3 Phase machines make sure your Phases are the right way round ? If not the machine will run backwards and not pump. Good Power source available? ? Make sure you have a good consistent power source that is dedicated to your machine and will not trip out. If the power keeps dropping out you could end up damaging your machine and its components. Diesel Rendering or Plastering Machines Oils ? Check your Engine, hydraulic and compressor oil levels. Fuel level ? It sounds obvious but make sure your machine is full of diesel. If your machine has a full tank of diesel at the start of the day then it should remove the potential stress and hassle of running out halfway through a spray. Remember they are classed as plant machinery so using Red Diesel is fine. Engine coolant level ? If it runs out of coolant your machine will over heat and cut out. This causes downtime and could result in costly repairs. Grease points greased? ? This ensures all the parts on the machine that are supposed to move can move freely and free from contamination, extending the life of your machine parts.

For more information on Blog: Getting the most out of your Rendering and Plastering Machine talk to CES Hire Ltd