Measuring Lacquer on Rough Surfaces – Ideal Probe for the Job

Irregular surface structures, or “roughness” – as typically found on grey cast iron or sand-blasted steel – complicate the process of measuring the thickness of overlying paint layers. The unevenness of the substrate’s surface can cause large fluctuations in the measured values. This leads to uncertainties in the interpretation of the results and makes it difficult to monitor the coating process. The underlying surface roughness always affects an overlying paint layer. However, it is difficult to make a quantitative assessment of the degree of interference because this depends on several parameters, such as the geometry of the roughness and the thickness of the lacquer. When measuring with a single-poled probe, measurement positions over roughness peaks or valleys may lead to different readings despite uniform paint thickness. The magnetic field lines are affected differently by the valleys and the peaks. In dual-poled probes this effect, and thus the influence of the roughness is significantly reduced – which consequently reduces the number of measurements required to assure an acceptable mean and standard deviation The dual-poled probe V7FKB4 used in combination with one of the FISCHER FMP handheld instruments or with the table-top FISCHERSCOPE® MMS® PC2 (module PERMASCOPE®) is especially developed to accurately measure paint layers atop rough surfaces. Compared to those attained with single-poled probes, significantly lower coefficients of variation and higher repeatability precisions are achieved, as shown in Table 1. The measurement accuracy is very dependent on careful calibration. The V7FKB4 probe reduces not only the calibration effort on original pieces but also the number of measurements required to verify the results. For precise measurement of paint layers on rough surfaces, the dual-poled magnetic induction probe V7FKB4 is ideal when used together with a device from the FMP family of handheld instruments or the FISCHERSCOPE® MMS® PC2. The expansion of the magnetic field lines between the two poles minimises the measurement variations induced by the roughness, providing the levels of precision and accuracy expected from FISCHER. UK Company 01590 684100 or info@fischergb.co.uk http://www.fischergb.co.uk

For more information on Measuring Lacquer on Rough Surfaces – Ideal Probe for the Job talk to Fischer Instrumentation